Z Automotive Tazer JL Module / Programmer

Z-Automotive Tazer JL Mini

Tazer JL Mini is to be an essential tool for owners of the new 2018+ Wrangler JL.

Simple, plug-in installation – simply unplug the SGW module and plug the Tazer JL Mini in its place. Located above the OBD2 Diagnostic connector.

There are two sets of features – those that program the vehicle to accommodate modifications made to the Jeep, and “live” features..

These are all accessed using the dash display, using steering wheel buttons to navigate the menus.

Settings – once the Tazer is “married” to the Jeep, the following menus can be accessed. Unmarrying the Tazer JL will bring the settings back to stock.

Perf menu:

• Adjust for alternate tire sizes up to 41″
• Adjust for alternate axle gear ratios
• Adjust for an alternate transfer case LO range ratio

TPMS menu:

• Disable the TPMS system if desired
• Change front/rear TPMS warning PSI limit
• Radio menu:
• Disable the Backup camera
• Enable Cargo/front/undercarriage Camera input
  Enable CD audio input
• Disable TravelLink (weather warnings included)

Lighting Menu:

• Change DRL region (type)
• Change DRL location
• Disable DRL Dropout
• Enable Fog lamp output
• Disable Fog lamp dropout
• Disable Halo’s
• Set LED 3rd brake light type
• Set LED tail lamp type
• Set the LED front turn signal type
• Set Trailer Tow output for use with Mopar kit

Other menu:

Disable/Enable Electronic sway bar – for axle swaps or to run disconnected at any speed or drive mode
Disable/Enable Front Axle Disconnect
Disable/Enable Front and Rear Lockers
Enable Aux switch settings on the radio
Enable Blind spot detection (sensors required)
Change cluster splash screen to Wrangler/Sahara/Rubicon
Enable/Disable PANIC button on remoteLive features:
Light shows: Can be accessed from the key fob or from the on-screen menu. 6 pre-set light shows and 3 make-your-own shows included. Set from the factory to only operate when parked, but can be unlocked for off-road, parade, and emergency personnel use.Disable Navigation in-motion lockout – enter addresses while the vehicle is moving
Disable camera lockout – use the backup camera and/or add cargo/front/undercarriage camera at any speed for any length of time
Auto Traction Kill – can be set to turn off traction control upon start-up
Auto StopStart Disable – can be set to disable AutoStopStart upon vehicle start-up
AutoPark Disable – can override the AutoPark system
TurnCAM – can turn on the backup camera whenever the turn signals are used (great for when the doors are off)
0-30 and 0-60 timers
Cooldown mode – run engine fans when the Jeep is off, to aid in cooldown
Winch mode – raise engine idle to 2000 RPM while winching or jumping another vehicle
Clear the Check engine light